René Descartes had seen light separated into the colors of the rainbow by glass or water, though the source of the color was unknown. This inconsistency caused confusion amongst later geometricians. with sides which were not parallelograms). Euclid defined the term in Book XI as "a solid figure contained by two opposite, equal and parallel planes, while the rest are parallelograms", however the nine subsequent propositions that used the term included examples of triangular-based prisms (i.e. Like many basic geometric terms, the word prism ( Greek: πρίσμα, romanized: prisma, lit.'something sawed') was first used in Euclid's Elements. Most frequently, dispersive prisms are equilateral (apex angle of 60 degrees). However it is often chosen so that both the incoming and outgoing light rays hit the surface at around the Brewster angle beyond the Brewster angle reflection losses increase greatly and angle of view is reduced. The top angle of the prism (the angle of the edge between the input and output faces) can be widened to increase the spectral dispersion. Fused quartz, sodium chloride and other optical materials are used at ultraviolet and infrared wavelengths where normal glasses become opaque. Unfortunately, high-dispersion regions tend to be spectrally close to regions where the material becomes opaque.Ĭrown glasses such as BK7 have a relatively small dispersion (and can be used roughly between 3 nm), while flint glasses have a much stronger dispersion for visible light and hence are more suitable for use as dispersive prisms, but their absorption sets on already around 390 nm. Therefore, the resulting dispersion is not a simple sum of individual contributions (unless all prisms can be approximated as thin ones).Ĭhoice of optical material for optimum dispersion Īlthough the refractive index is dependent on the wavelength in every material, some materials have a much more powerful wavelength dependence (are much more dispersive) than others. Main article: Multiple-prism dispersion theoryĪligning multiple prisms in series can enhance the dispersion greatly, or vice versa, allow beam manipulation with suppressed dispersion.Īs shown above, the dispersive behaviour of each prism depends strongly on the angle of incidence, which is determined by the presence of surrounding prisms. Regions 0, 1, and 2 have indices of refraction n 0.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |